MUSETEX Y6 PC Case, Pre-Installed 7 Infinity Mirror PWM ARGB Fans, ATX Mid Tower Computer Case

This MUSETEX ATX PC case exceeded my expectations with its spacious design, strong airflow, and impressive pre-installed ARGB fans, making it a great choice for anyone who wants a case that looks fantastic, stays cool, and offers plenty of room for a clean and powerful build.

Alexander Kazanski · 2026-04-05 · via amazon

everything about this was great it came pre installed with fans very easy to cable manage and looked phenomenal and never overheated very cheap for what it was and handles very nice all case buttons worked exactly how they should’ve and it was simple, the case is quite large so make sure you have enough desk room

etahadna d. · 2026-03-01 · via amazon

Overall the case is very nice and arrived in perfect condition. All six of the stock case fans work fine. If you're not going with liquid cooling and plan to add more fans like I did, I would suggest moving the two side intake and the rear exhaust down to the bottom. Leave the other three on the top. The reason for this is that the stock fans are 6pin and connect to an adapter cable that has your 3pin argb and 4pin pwm. There are two adapters cables, each of which connect 3 fans, but each branch that connects to a fan is pretty short, and spreading the fans apart will make it near impossible to connect all of them. As others have mentioned, a full atx board goes right to the bottom of the case. You'll only be able to fit flat cables under the board, and even that is a bit challenging. PLAN YOUR WIRING OUT AHEAD OF TIME AND GET YOUR CABLES IN PLACE BEFORE INSTALLING YOUR MOBO. You'll never fit anything under there once the mobo is in place. The rear chamber was spacious enough for all of the excess cable, granted I didn't install any drives back there. I'm no expert at cable management, but I was able to get everything tucked and tied without having to force the back on lol. I ended up using the HDD compartment in the top right for a fan hub. This is a very nice looking case and has a spacious interior for airflow. If you plan everything out ahead of time you shouldn't have too much trouble.

Kathy · 2025-12-21 · via amazon

The pros: good looking, solidly built, quiet fans, air flow, dust filters, easy to assemble, price. The cons: build space, cable cutouts, cable management. This is a good case overall, but it’s definitely best for a *MICRO ATX* motherboard. You can use a standard ATX, but space is limited. I think cases need silicon cable cutout liners (to hide where the cords are stored and eliminate sharp edges; aesthetically more pleasing). Also, there are no cutouts and absolutely no space at the bottom, if you’re using an ATX MB (standard/full size MB), to route cables which, if you’re a stickler for cable management/going for the neatest look you can get, you’re better off spending a little extra for a case that has those features. This is my first build, and it wasn’t so bad that I couldn’t finish, but I will likely upgrade cases somewhere down the line for a more user friendly and cleaner looking case. Overall, great case for the price and I believe this might be one of the best (price to performance) if you’re doing a micro ATX build.

Brandon · 2025-02-24 · via amazon

I have built lots of PC's and have never had a case which was better for an easy install. Having the power supply behind the motherboard is much better than having it on the bottom. Sure the case is wider but that means plenty of room for cables instead of the customary squeeze job with a standard ATX case. I used an ATX motherboard and I don't see why some had problems with it. Asus Aura Sync worked perfeclty for the RGB fans and they are very quiet . I would not hesitate to but this case again. It's an amzing value

winet · 2026-02-05 · via amazon

Best Buy

Not tracked at this retailer

MSI

Not tracked at this retailer

Newegg

Not tracked at this retailer

Newegg (Open Box)

Not tracked at this retailer

VALUE SCORE

Price

$39.99

Price

$63.99